INSTALLING BELT GUARD
_
TOGETHER
1.Remove the belt and motor pulley.
2. Screws furnished | witli guard are "self threading" | ... |
BELT GUARD
SUPPORT BRACKET
\
SE
SCREW
screw them into holes | in | BELT GUARD | SUPPORT | |||
BRACKET, then | remove | them. |
|
|
| |
3. Position BELT | GUARD |
| SUPPORT | BRACKET | and | |
BELT GUARD | SUPPORT | as shown | and | install | the | |
screws ... make sure motor shaft is in CENTER of | ||||||
hole in SUPPORT. |
|
|
|
|
|
|
4. Install three CLIPS (furnished with guardi 90 ° apart starting with one clip at the end of the guard as shown
•.. LONG END of cl p facingAWAY from you.
BELT GUARD
BELT GUARD
\
BELT GUARD SUPPORT
\
PIVOT SCREW
/
/
CENTERED
OPENING
j__,_CLIPS
N
LONG END
BELT.
5.Reinstall ,motor pulley the same way it was when you aligned the belt,
6.Place belt on SAW'PULLEY ,.. insert end of belt through opening in END of guard,
7.Slip belt over motor pulley.
18
