3. Operate the
4. NOTE: Handle is spring loaded for engagement with screw head - must be pushed inward for disengagement whenever necessary to obtain a new grip on screw head.
5.Rotate tilt handwheel CLOCKWISE a few turns to till blade. Now rotate handwheel COUNTERCLOCKWISE
until it stops. Blade should now be square with table and pointer should point to "0".
If blade is SQUARE to table;
A.Check pointer
F POINTER DOES NOT point to the "O" mark on the bevel scale;
A. Remove Elevation Handwheel.
B. Loosen screw and adjust pointer ... using medium screwdriver.
C. Install Elevation Handwheel.
If blade is NOT SQUARE to table.., the 90 ° LIMIT STOP must be ADJUSTED.
1. Using a medium size screwdriver, loosen BOTH setscrews in 90 ° STOP COLLAR.
NOTE: If you can't reach the setscrews, turn the TILT
NANDWHEEL slightly.
2.ROTATE the STOP COLLAR moving it all the way to the end of TILT SCREW. (to the right).
3.TILT blade RIGHT or LEFT ... checking with your
square until blade is square to table. | COLLAR |
4.ROTATE STOP COLLAR moving it to the right until it
stops... TIGHTEN the setscrews.
5.Check POINTER. If it DOES NOT point to the "O" mark on the bevel scale...
A. Remove Elevation Handwheel.
B.Loosen screw and ad)ust pointer ... using medium screwdriver.
C.Install Elevation Handwheel.
45 ° | POSITION |
|
|
|
|
|
|
|
|
|
|
|
| |
TILT blade to LEFT as far as it will go. It will stop when |
|
| ||||||||||||
the PIVOT NUT is against the 45 ° STOP COLLAR. |
|
|
|
| ||||||||||
| A, | Place | an | ACCURATE | square | against | blade. | Make |
|
| ||||
|
| sure square is not touching the TIP of one o{ the |
|
| ||||||||||
|
| saw TEETH. |
|
|
|
|
|
|
|
|
|
| ||
If blade is 45 ° to table; |
|
|
|
|
|
|
|
|
| |||||
| A. | Check | pointer. |
|
|
|
|
|
|
|
|
|
| |
If | POINTER | DOES | NOT | point | to | the | 45 ° | mark | on | the |
|
| ||
scale; |
|
|
|
|
|
|
|
|
|
|
| POINTER points | to 45 ° mark. | |
| A. | Remove | Elevation Handwheel. |
|
|
|
|
| ||||||
|
|
|
|
|
|
|
| |||||||
| B, | Loosen |
| two | screws | on | scale | and | adjust scale | until | C. Install Elevation | Handwheel. | ||
|
|
|
| |||||||||||
31
