MOUNTINGSAW
1.From among the loose parts, find the following hardware:
4 Hex Head Screws. 5/16 - 18 x
4 Hex Nuts, 5/16- 18 (approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx. dia. of hole, 5/16 in.)
8 Flat Washers, (dia. of hole 11/32 in.)
2.Place saw on legs so that holes in bottom of saw line up with holes in top of legs.
3.Install screws, washers, Iockwashers and nuts as shown.
SAW BASE 17
END
STIFFENER"_t |
|
FLAT | ' |
LOCKWASHER"_'_' |
|
.Ex
/
/
13
If you mount the saw on any other bench, make sure that there is an opening in the/top of the bench the same size as the opening in the bottom of the saw so that the sawdust can drop through. Recommended working height is 33 to 37 inches from the top of the saw table to the floor.
ATTACHING AND ASSEMBLING TABLE EXTENSIONS
If you received Table Extensions with your saw (two furnished with Model No. 113.298031) or one furnished with Model No. 113.298151 ) attach them at this time.
If you have only one Table Extension, it may be attached to either side.
NOTE: When the Table Extension is attached to the left
side, it offers more support to the workpiece, especially when crosscutting or mitering long boards. When attached to the right side, it offers more support when curing wide panels.
If you attach the Extension to the left side, be sure to construct the Auxiliary Fence/Work Support and Push Block shown in "Basic Saw Operation" section.
1.From among the loose parts find the following hardware. NOTE: Double number of hardware if assembling extensions for Model 113.298031.
2 Corner Support Brackets
2 Corner Stiffener Brackets
8 Truss Hd. Screws
8 Ext. Lockwashers 1/4
8 Hex Nut
4 Hex Hd. Screws
4 Hex Nut 5/16 - 18
Assemble brackets with hardware as listed.
Insert
EXTENSION then through table. Install flat washer, Iockwasbers, and screw on the nuts . . . DO NOT
TIGHTEN.
BLOCK OF WOOD
\
/
Align front edge of extension with front edge of saw table. Pull Extension UPWARDS above table surface ...
SLIGHTLY TIGHTEN SCREWS using 1/2 in. wrench.
Using small block of hardwood and hammer, l:ap extension DOWNWARDS at front, center & rear, unti it is EVEN with table surface ... TIGHTEN SCREWS.
