Sears 73311, 73328, 73321, 73318 mnstaHUationinstructions continued, Step, Ao i- p, I tJ,11, Head

mnstaHUationinstructions (continued)

Step 8

installing the Anti-Tip Device

WARNING:

o Range must be secured with an approved Anti- Tip device°

o Unless properly installed, the range could be tipped by an adult or a child standing, sitting or leaning on an open door or drawer.

. After installing the Anti-Tip device, make sure it

is in place by carefully attempting to tilt the range forward°

o This range has been designed to meet al! rec-

ognized industry tip standards for all normal conditions.

°The use of this device does not preclude tipping of the range when not properly instatled_

°If the Anti-Tip device supplied with the range does not fit this application, use the universal Anti- Tip device WB02X7909

1.Mark the wall where the RIGHT EDGE of the range is to be located° Be sure to allow for the countertop overhang if you intend to install the range next to cabinets.

!

Back of

WallboardRange

Anti-Tip

Device

Wood Screw

4.For wood construction, drill a pilot hole at an angle of 20 degrees from the horizontal. A nail or awl may be used if a drill is not available,

Mount the Anti-Tip device with the screw provided,

For cement or concrete construction, you will need a 1/4" x 11A''lag bolt and a 1/2" ODo sleeve anchor,

which are not provided, Drill the recommended size hole for the hardware.

			Ao i- p I
Slotted	_	I Hr_____.._		I
Head(&__		I _tJ,11
Screw	_ _"*_'_',_		I t
	"_"_--	_. I !ll	t l Wallplate I
	Approx	20 °		i
	./"	.'_z"	1	Marked Edge
	.1	_ :,'e	.t--	of Range

2.Locate the outside edge of the dewce 2¼ toward the center of the range from the marked edge of the range..

3.Using the device as a template, mark the position of the hole for the screw.

Install the sleeve anchor into the drilled hole and then install the tag bolt through the device, The bolts must be properly tightened as recommended for the hardware.,

5.Slide the range against the wall, and check for proper installation by grasping the front edges of the rear surface unit openings and carefully attempting to tilt the range forward..

WHEN ALL HOOKUPS ARE COMPLETED

MAKE SURE ALL CONTROLS ARE LEFT IN THE OFF POSITION.MAKE SURE THE FLOW OF COMBUSTION ANDVENTILATION AIR TO THE RANGE IS UNOB- STRUCTED.

10