installation Instructions (continued)
GENERAL
=See Dimensions and Clearances on page 2 for all
•The range may be placed with 0" clearance (flush) at the back wall and side walls of the range.
TOOLS YOU WILL NEED
•Phillips screwdriver ° Pencil and ruler
o Two pipe wrenches (one for backup) °
°3/16"
• Nut driver
LOCATION
Do not locate the range where it may be subject to strong drafts. Any openings in the floor or wall behind the range should be sealed. Make sure the openings around the base of the range that supply fresh air for combustion and ventilation are not obstructed by car- peting or woodwork.
In addition, for LP gas conversion, you will need:
°5/16"
• 1/2" opemend wrench
ADDITIONAL MATERIALS YOU MAY NEED
° Gas line shutoff valve
PROTECT YOUR FLOOR
Your range, like many other household items, is heavy and can settle into soft floor coverings such as cush- ioned vinyl or carpeting° Use care when moving the range on this type of flooring. It is recommended that the following simple and inexpensive instructions be followed to protect your floor.
The range should be installed on a sheet of plywood (or similar material) as follows: When the floor cover- ing ends at the front of the range, the area that the range will rest on should be built up with plywood to the same level or higher than the floor covering. This will allow the range to be moved for cleaning or ser- vicing.
°Pipe joint sealant or pipe thread tape with Teflon* that resists action of natural and LP gases
°Flexible metal appliance connector (1/2" I.D.). A 5- foot length is recommended for ease of installation but other lengths are acceptable. Never use an old con- nector when installing a new range.
•Flare union adapter for connection to gas supply line (3/4" or t/2" NPT x 1/2" I.D)
o Flare union adapter for connection to pressure regu- later on range (112" NPT x 1/2" ID.)
"Teflon: Registered trademark of DuPont
MODEL AND SEROALNUMBER LOCATION
The model and serial numbers are on a label located
on the front frame of the range, behind the kick panel
PREPARATION
•Remove all tape and packaging. Be sure to remove plastic film that covers some chrome parts (around oven doors, side trim).
o Take the accessory pack out of the oven.
°Check to be sure that no range parts have come loose during shipping..
