1
-II
W
W
-II
Y
Putting the receiver into operation
Unsecure the rack mount “ears” 1 from the rack.
Guide the BNC cables through the holes in the rack mount “ears” as shown in the diagram on the left.
Screw the antenna holders Z to the BNC sockets W using the supplied washers Y and nuts X.
Z X
Z Secure the antenna holders Z to the handles of the receiver using two
of the supplied screws respectively.
[
-II
\
Connect the two BNC connectors [to the BNC sockets O and Rat the rear of the receiver.
Slide the receiver into the 19" rack.
Resecure the rack mount “ears” 1 to the rack.
Connect the antennas \ to the BNC sockets W.
Align the antennas upwards in a
| Connecting and positioning remote antennas |
| Use remote antennas when the position of the receiver is not the best |
| antenna position for optimum reception. Remote antennas are available |
| as accessories. |
| Connect the remote antennas to the BNC sockets Oand Rusing a low- |
| attenuation |
| |
| as accessories with length of 1 m, 5 m and 10 m (see “Accessories” |
N O P Q R S | on page 44). |
If you connect active antennas (e.g. A 3700, AD 3700) or antenna boosters (e.g. AB 3700), switch on the DC supply voltage for external
active antennas and antenna boosters (see page 31) so that the LEDs N and/or S light up;
if you do not connect active antennas or antenna boosters, switch off the booster supply voltage so that the LEDs N and/or S do not light up.
15