Sennheiser EM 3731-II, EM 3732-I, I EM 3732-II Command +12 dB

Adjustment tips for the operating menu

		Booster Feed On
		7 8
DEV	M	save digital audio
	777.005 Hz	processing
	U.01 CH	sync
	U.01 CH	HDP AF COM esc
	BANK	HDP AF COM esc

sync

+12	48

oster AF Out

Cloc

+12 dB

+12

Change to the setting mode of the “Booster” menu. The current setting starts flashing.

Turn the jog dial 7 to change the setting to “Booster Feed On” or “Booster Feed Off”.

Press the save button 8.

The selected setting is stored. When the booster supply voltage is switched on, the two LEDs N and S light up. The display changes to the selection mode of the operating menu.

Adjusting the audio output level

Via the “AF Out” menu, you can adjust the maximum output level of the audio outputs (AF Out and Command).

With the EM 3732 COM-II twin receiver, the audio level of the Command output 1 L corresponds to the level of the audio output 1 M and the audio level of the Command output 2 J corresponds to the level of the audio output 2 K.

The following figures are a guide to the best settings:

•Line level: +5 to +18 dB

•Microphone level: –10 to +4 dB

To obtain the best signal-to-noise ration, adjust the respective maximum audio level to the settings shown above.

Change to the setting mode of the “AF Out” menu. The current setting starts flashing.

			7 8
DEV		M	save digital audio
	777.005 Hz		processing
	U.01 CH	HDP AF COM	sync
	U.01 CH		esc
	BANK		esc

sync

Turn the jog dial 7 to adjust the audio output level. The display shows the selected audio output level.

Press the save button 8.

The selected setting is stored. The display changes to the selection mode of the operating menu.

	3
18	48
18	20
Out	Clock Comm

Selecting the sampling rate for digitalization

Via the “Clock” menu, you can select the sampling rate with which the analog signal is digitalized and output via the digital balanced XLR-3M audio output G. You can choose between the sampling rates “44.1 kHz”, “48 kHz”, “88.2 kHz”, “96 kHz” and “Ext.”.

“Ext.” means that the receiver will use one of above sampling rates from the external word clock generator. In this case, you first have to connect an external word clock generator to the BNC socket H (see “Connecting an external word clock generator” on page 17) and switch it on.