Adjustment tips for the operating menu
Freq. occupied | B.Ch |
|
776. B.Ch
000 1.01
Tune Ban
B.Ch 776.
U.01 000
MHz
776 960
UHFMHz
B.Ch
776.000MHz 1.
.Ch
.16 CEL 30.Ch Name Squel
|
|
| + , - / 0 1 2 3 4 5 6 |
|
|
|
| 7 8 9 * ; < = > A A B | EL |
|
|
| C D E F G H I J K L M N |
|
|
|
| OPQRSTUVWXYZ |
|
|
|
| 7 8 |
|
DEV | M |
| save | digital audio |
| 777.005 Hz |
| sync | processing |
| U.01 CH |
|
| |
| HDP | AF COM esc |
| |
| BANK |
| ||
|
|
|
| sync |
You can only select channels that are not occupied. If, during the last scan, channels were detected that were occupied, these channels are marked with a warning triangle and “Freq. occupied”.
After you have selected the frequency bank and the channel, press the save button 8.
The selected frequency bank and the selected channel are set. The display changes to the selection mode of the operating menu.
Changing the receiving frequency for a channel in the frequency bank “U”
Each receiver has seven frequency banks. Each of the channels in the frequency banks “1” to “6” has been
Change to the setting mode of the “Bank.Ch” menu and select the frequency bank “U” and one of the channels “01” to “60” whose frequency you want to change and store (see “Selecting a frequency bank and a channel” on page 29).
The receiving frequencies of the channels in the frequency banks “1” to “6” cannot be changed. When you have selected one of the frequency banks “1” to “6” and then select the “Tune” menu, the receiver automatically switches to channel “01” of the frequency bank “U”.
Change to the setting mode of the “Tune” menu and select the receiving frequency you want to store (see “Setting the receiving frequency” on page 29).
The selected receiving frequency is set and stored on the selected channel of the frequency bank “U”, i.e. the previously stored frequency is overwritten. The display changes to the selection mode of the oper- ating menu.
Entering a name
Via the “Name” menu, you can enter a freely selectable name for the receiver. The name can be displayed on the status display and can consist of up to six characters such as:
•letters (without pronounciation marks),
•number from 0 to 9,
•special characters and spaces.
Change to the setting mode of the “Name” menu. The first character of the name starts flashing.
Turn the jog dial 7 to select a different character. The selected character starts flashing.
Press the jog dial 7 to confirm the selected character.
The first character is accepted and stops flashing. The next character starts flashing.
Repeat the last two steps to enter the remaining characters.
30