Sennheiser EM 3731-II, EM 3732-I, I EM 3732-II Command Product overview, Overview of the EM 3731-II/EM 3732-II/EM3732 COM-IIreceivers

Product overview

Overview of the EM 3731-II/EM 3732-II/EM 3732 COM-II receivers

	100	100	776.000 z		100	100	776.000 z
	A RF B	% DEV	M		A RF B	% DEV	M
True Diversity Receiver EM 3732-II	300	PEAK	H		300	PEAK	H
	10		01.01CH		10		01.01CH
	30	50	BANK HDP	AF COM	30	50	BANK HDP	AF COM
	μV	10			μV	10

EM 3732-II-XXX-X

RF-OUT FREQ. RANGE: 776 – 960 MHz

A Front panel

1Rack mount “ears”

2¼“ (6.3 mm) jack socket for headphones

3Headphone volume control

4Display (see next page)

5Warning triangle for indicating error states

6esc button, backlit

7Jog dial

8save button, backlit

9sync button, backlit

0Headphone button, backlit (except EM 3731-II single receiver)

AInfra-red interface

BDisplay for external word clock synchronization

C button, backlit

B Rear panel

D3-pin mains socket

ELED for LAN data transmission

FRJ 45 socket for LAN connection

GXLR-3 socket (male) for digital audio output, digital balanced, AES3

HBNC socket for word clock input (75 Ω)

IBNC socket for word clock daisy chain output (75 Ω)

JXLR-3 socket (male) for Command output 2*, balanced (EM 3732 COM-II twin receiver only)

KXLR-3 socket (male) for audio output AF Out 2*, balanced (except EM 3731-II single receiver)

LXLR-3 socket (male) for Command output 1*, balanced (except EM 3731-II single receiver)

MXLR-3 socket (male) for audio output AF Out 1*, balanced

NLED for booster supply of antenna input A

OBNC socket, antenna input A (ANT A – RF in, DC out, 50 Ω)

PBNC socket, daisy chain output A (ANT A – RF out)

QBNC socket, daisy chain output B (ANT B – RF out)

RBNC socket, antenna input B (ANT B – RF in, DC out, 50 Ω)

SLED for booster supply of antenna input B

TLabel with hazard warnings

UType plate

VLabel with frequency range for daisy chaining

*The audio outputs marked with the number “1” output the audio signal of the left receiver of the twin receiver (as viewed from the front); the audio outputs marked with the number “2” output the audio signal of the right receiver.