Servis-Rhino CY84 manual Protective, Integral Shields Lift-Type

MAINTENANCE

Protective, Integral Shields - Lift-Type

Protective Driveline Shields should be installed on Drivelines as shown in Figure Mnt-0013below. The protective Integral Shields are assembled onto nylon bearings and should turn freely - but should not spin. Greasing the nylon bearings is not required but will not harm them. Each Shield Bearing is composed of two nylon bearing halves. They may be removed by prying the locking lug of the nylon bearing out of the slot in the Shield and pulling the bearing out through the slot. To replace the nylon bearings, align the slot in the shield over the groove in the Yoke of the Driveline. Insert the beveled tip of the nylon bearing into the slot of the shield and push into place. Push the locking lug of the nylon bearing into the slot until it snaps into place.

Driveline Integral Shields must be in place at all times when operating.

CY84 03/08 Maintenance Section 5-5

© 2008 Alamo Group Inc.

MAINTENANCE