ASSEMBLY
ASSEMBLY
Driveline Attachment
(Figure Asm-0044)
Remove washer, castle nut, and cotter pin from wing gearbox shaft. Install clutch yoke on shaft. Attach yoke to clutch by inserting spacer flat (1) between yoke and clutch. Insert 5/16 x 3-1/2 bolts
(2)and install locknuts (3). Tighten securely. Install washer and castle nut on gearbox shaft between yoke ears. Tighten Mounting Nut and the back off to allow approximately.015 clearance (Figure Asm- 0044).
Install Canopy Shield over
Torque Limiter and make certain it remains installed at all times when operating this Mower.
Gearbox Shield Assembly
(Figure Asm-0045)
Install the Gearbox Shield (1) using two existing bolts in gearbox top cover plate. Tighten all hardware in accordance with the torque chart in the Maintenance section of this manual. Install wing nut (2) hand-tight for ease of raising shield for service.
DO NOT operate if Shields are inoperative or removed.
CY84 03/08 | Assembly Section |
© 2008 Alamo Group Inc.
