ASSEMBLY
ASSEMBLY
Optional A-Frame Assembly
(Figure Asm-0032)
To assemble the Mower’s A-Frame, follow the procedures listed below:
1.Insert bushing (5) into lower end of each A- Frame half (1 & 2). Position each A-Frame half so the large hole in the top is towards the trac- tor. Install 3/4 x 2" bolt (10) with Flatwasher
(14)through bushing (5) in A-Frame half (1 & 2) and rear hole in inside Main Frame lug. Install locknut.
2.Install bushing (8) between braces (3) through top rear hole of A-frame and insert bolt (12), flatwasher (14) and locknut (13).
3.Install bushing (22) between A-Frame halves (1 & 2) and insert bolt (23) and locknut (13). Install bushings (6) through Braces (4) and install bolt 3/4 x 5 (10), flatwashers (14) and locknut (13).
4.Attach Braces (3) to Braces (4) with bushings (6), bolt 3/4 x 2-1/2 (16), and locknut (13). Retain the rear of Braces (3) together with bushing (15), bolt 3/4 x 2-1/2 (11) and locknut
(13).Attach braces (4) together with bolt 3/4 x 1-1/2 (17) and locknut (13).
5.Install Brace supports (4) to the rear lugs on the
Main Frame with bolts 3/4 x 2 (10), flatwashers (14), bushings (6) and locknuts (13).
Single Tail Wheel Assembly - Lift-Type
(Figure Asm-0033)
Insert bushing (2) in lug centered behind gearbox. Attach the tail wheel beam (1) to the lug on the mower deck using bolt (3) and locknut (4).
Attach the brackets (5 & 6) to the main deck using bolts (8), washer (9), & nuts (10). Note: Formed leg with adjustment holes must point to rear and should be on each side of tail wheel beam.
Install bolts (11) & nuts (12) on top and bottom of tail wheel beam. Insert through pair of holes which will give approximate desired cutting height. Tighten all bolts per Torque Chart.
CY84 03/08 | Assembly Section |
© 2008 Alamo Group Inc.
