OPERATION
Gearbox Leaking | Damaged Oil Seal. | Replace Seal. |
| No Oil Seal. | Install Oil Seal. |
| Oil too light. | Use EP140. |
| Bent Shaft. | Replace Oil Seal and Shaft. |
| Oil Seal Race rough. | Replace Shaft or repair Race. |
| Oil Seal installed wrong. | Replace Seal. |
| Oil Seal not sealing in the housing. | Replace Seal or use a sealant on O.D. |
|
| of Seal. |
| Bearings loose. | Adjust Bearings. |
| Vent Plug stopped up. | Open Vent Plug. |
| Oil level too high. | Drain oil to proper level. |
| Gasket damaged. | Replace Gasket. |
| Bolts loose. | Tighten Bolts. |
Driveline Integral Shields | Integral Shields deformed. | Replace Shield. |
Rattling or Not Turning Freely | Nylon Bearing worn. | Replace Nylon Bearing. |
Rapid Clevis Wear | Washer not used. | Install washers above and |
|
| below drawbar. |
Clevis Bending or Spreading | Using Pin or Bolt not tightened. | Use 1” grade 5 or 8 Bolt & tighten Nut. |
Open. |
|
|
CY84 03/08 | Operation Section |
© 2008 Alamo Group Inc.