ASSEMBLY

ASSEMBLY

Jackshaft Bearing Support Assembly

(Figure Asm-0047)

Attach the Jackshaft bearing support brackets (1&2) to the tongue. Loosely attach bearing support brackets by using 1/2” x 7-1/2” bolt (3), washer (5), bushing (4) and nuts (6). Be sure that support brackets are assembled through rear hole on the tongue. Then assemble Snap Ring (7) Bearing (8) and housing assembly (9) and install with 3/4” x 7" bolt (10) and nut (11). Install Spacer (12) with 1/2” x 7-1/2”bolt (13) and nut (14) leaving installed loosely. Tighten bolt (13). NOTE: Do not tighten to point of collapsing spacer (12).Tighten bolts (3 & 10) NOTE: Do not over tighten. Make sure Carrier Bearing (9) pivots in supports and complete assembly pivots on lower bolt. Slide Jackshaft through bearing (9) and Snap on to the driveline (15).

NOTE: ALL Yokes must be set as shown for proper phasing.

CY84 03/08

Assembly Section 3-10

© 2008 Alamo Group Inc.

Page 88
Image 88
Servis-Rhino CY84 manual Jackshaft Bearing Support Assembly