Sharp AL-1456, AL-1555, AL-1045, AL-1255 operation manual Misfeed Removal

MISFEED REMOVAL

When the misfeed ( ) indicator blinks or blinks in the display, the unit will stop because of a misfeed. If a misfeed occurs when using the SPF/RSPF, a number may appear in the display after a minus sign. This indicates the number of the originals that must be returned to the original feeder tray after a misfeed. Return the required number of originals. Then this number will disappear when copying is resumed or the clear () key is pressed. When the SPF/RSPF misfeeds an original sheet, the unit will stop and the SPF/RSPF misfeed ( ) indicator will blink, while the misfeed () indicator will remain off. For a misfeed of originals in the SPF/ RSPF, see "E: Misfeed in the SPF/RSPF" (p.66).

If the unit is turned on with the lower side cover open, the misfeed ( ) indicator will blink. In this case, close the lower side cover. The misfeed ( ) indicator will go out.

1Open the multi-bypass tray (AL-1555), and side cover, in that order.

To open the multi-bypass tray, see "The multi-bypass tray (AL-1555)" (p.17). To open the side cover, see "INSTALLING THE TD CARTRIDGE"

(p.10).

2Check the misfeed location. Remove the misfed paper following the instructions for each location in the illustration

below. If blinks in the display, proceed to "A: Misfeed in the paper feed area" (p.64).

If the misfed paper is seen from this side, proceed to "C: Misfeed in the transport area". (p.65)

If paper is misfed here, proceed to "B: Misfeed in the fusing area". (p.64)

If paper is misfed here, proceed to "D: Misfeed in the lower

paper feed area". (p.66)

8

If paper is misfed here, proceed to "A:

Misfeed in the paper feed area". (p.64)

63