8 TROUBLESHOOTING THE UNIT

This chapter describes misfeed removal and troubleshooting.

For problems with the printer function or the scanner function, see the online manual or the Help file for the printer/scanner driver.

TROUBLESHOOTING

If any problem occurs, check the list below before contacting our Technical Assistance Department.

Problem

Possible cause

Solution

Page

 

 

Unit plugged in?

Plug the unit into a grounded outlet.

12

 

Unit does not

Power switch on?

Turn the power switch on.

12

 

Side cover closed securely?

Gently close the side cover.

11

 

operate.

 

 

Front cover closed?

Gently close the front cover and then

11

 

 

 

close the side cover.

 

 

 

 

 

 

Is the original placed face

Place the original face down on the

 

 

Blank copies

down on the original table

original table or face up in the SPF/

47, 48

 

or face up in the SPF/

RSPF.

 

 

 

 

 

RSPF?

 

 

 

 

 

 

 

 

 

Is original image too dark or

Adjust the exposure manually.

49

 

 

too light?

 

 

 

 

 

 

Copies are too

Is the unit in the automatic

Adjust the automatic exposure level.

50

 

dark or too light.

exposure mode?

 

 

 

 

 

 

Is the unit in the photo

Cancel the photo exposure mode.

49

 

 

exposure mode?

 

 

 

 

 

 

Dust, dirt,

Original table or original

Clean regularly.

59

 

cover dirty?

 

 

smudges appear

 

 

 

Original smudged or

Use a clean original.

 

on copies.

blotchy?

 

 

 

 

 

 

Striped copies

Is transfer charger clean?

Clean the transfer charger.

60

 

 

Non-standard paper used?

Use standard paper. If using special

 

 

 

 

papers, feed the paper through the

14

 

 

 

single bypass/multi-bypass tray.

 

 

 

Paper curled or damp?

Store paper flat in the wrapper in a

 

 

 

dry location.

 

Paper misfeeds

 

 

 

Pieces of paper inside unit?

Remove all pieces of misfed paper.

63

 

frequently.

 

Paper guides in the paper

Set the guides properly depending on

15

 

 

 

 

tray not set properly?

the paper size.

 

 

 

8

 

 

 

 

 

Too much paper in the

Remove excessive paper from the

 

 

paper tray or multi-bypass

tray.

16

 

tray?

 

 

 

Is the paper too heavy?

Use paper within the specified range.

14

 

Images rub off the

Paper damp?

Replace with dry paper. If the unit is

 

 

copy easily.

 

not used for long time, remove the

71

 

 

paper from the paper tray and store it

 

 

 

 

 

 

 

in its wrapper in a dry location.

 

 

61

Page 63
Image 63
Sharp AL-1255, AL-1555, AL-1456, AL-1045 operation manual Troubleshooting the Unit