Automatic exposure adjustment
This automatic exposure level will remain in effect until you change it again by this procedure.
The automatic exposure level can be adjusted to suit your copying needs. This level is set for copying from the original table and copying from the SPF/RSPF respectively.
1When adjusting the automatic exposure level for copying from the SPF/RSPF, place an original in the original feeder tray and make sure that the SPF/RSPF ( 
) indicator lights up. When adjusting the level for copying from the original table, make sure that no original is left in the original feeder tray.
2
3
Press the exposure mode selector key to select the photo ( 
) mode.
Press and hold down the exposure mode selector key for approximately 5 seconds. The photo (
) indicator will go out and the AUTO indicator will begin to blink. One or two exposure indicators corresponding to the automatic exposure level which has been selected will light up.
4Press the light ( 
) or dark ( 
) key to
lighten or darken the automatic exposure level as desired. If exposure level 2 is selected, the two
5Press the exposure selector key. The AUTO indicator will stop blinking and light up steadily.
50
