Sharp AR-FX13 appendix Gently close the Rspf, Press the # key

HOW TO USE THE FAX FUNCTION

When placing the Original on the document glass:

1 Confirm that there are no original(s) in the RSPF, and open the RSPF.

2 Place the original face down on the document glass. Align the original according to the original scale in the illustration below. (Line up the center of the edge of the original with the

( ) mark.)

Original scale

mark

3 Gently close the RSPF.

Note	When using the document glass, do not set
	original(s) in the SPF/RSPF.

4 If needed, set the original size, resolution, and contrast. Continue with the "DIALING AND TRANSMITTING" section.

5 Press the [START] key ( ).

The set original size
appears in the display
and then scanning
begins.
After the [START] key (	) is pressed, the
Note set original size appears in the display.
(EX. )
READING	#001
A4	100%

Make sure that the displayed size is the same as the actual original size. (The factory default setting for the original size is A4.) If the displayed size is not correct, press the [CLEAR ALL] key () to stop operation and then change the original size setting. (See "ORIGINAL SIZE" (p.53)) When faxing from the document glass, if the size of the original is different from the specified size, part of the image may be cut off.

6 If you have more than one original to read into memory, place the next page, and press the [START] key ( ) to read each page.

Go to step 7 after the last page has been scanned.

7 Press the [#] key.

Transmission begins.

52