Sharp AR-FX13 appendix Enter the name of the destination with the numeric keys

INITIAL SETTINGS

9 Enter the name of the destination with the numeric keys.

Enter the name of the location or party by pressing numeric keys as described in "HOW TO ENTER CHARACTERS" on page 20 (maximum of 20 characters). If you do not want to enter a name, skip this step.

10 Press the [OK] key.

SP. FUNC

11 Press the [] key () or [] key ( ) to select a Chain Dial setting.

	If you wish to set the
	number as a Chain Dial
	number, select "1:SET".
SP. FUNC	Otherwise, select
	"2:CANCEL".
	(See "CHAIN DIALING"
	(p.59))

If the number is not set as a chain dial number, the communication speed and international communication mode cannot be selected. Press the [OK] key and go to step 18.

12 Press the [OK] key.

13 Press the [] key () or [] key () to select the communication speed.

The selections are as

follows:

1:33600bps

SP. FUNC 2:14400bps 3:9600bps 4:4800bps

For international dialing, if you find that line Note noise necessitates a slower transmission

speed, set the appropriate transmission speed. If you are not sure if a slower speed is required, set the speed normally.

14 Press the [OK] key.

15 Press the [] key () or [] key () to select the international communication mode.

The selections are as

	follows:
	1:NO
SP. FUNC	2:MODE 1
	3:MODE 2
	4:MODE 3

Sometimes when faxing internationally, line Note noise can cause the transmission to stop

momentarily. To reduce these delays, please intially select mode 1, if still unsuccessful then try mode 2, and if still not successful, try mode 3 which is combination of the first two modes.

16 Press the [OK] key.

Return to Step 5 to store another number.

SP. FUNC

17 Press the [MENU] key.

	Press the [MENU] key a
	number of times until you
	exit.
SP. FUNC	If the number is a Rapid
	key number, you can
	write the name on the
	label above the
	appropriate Rapid key.

You may need to add a pause between Note certain digits in the number to allow time for

connection. For example, if you are on a PBX telephone system that requires an access number, such as "9", to be dialed to access an outside line, you will need to enter a pause between the access number and the fax number of the other party. Pauses are entered by pressing the [REDIAL/PAUSE] key (2 seconds per pause). If necessary, several pauses can be entered in a row.

42