Sharp LC-19D1S, LC-19D1E operation manual Power Control menu, Setup menu, No Operation Off

Press MENU and the MENU screen displays. Press c/d to select “Setup”.

• See page 14 for setting PIN.

4 Press a/b to select “Yes”, and then press OK.

5 You can set language and country the same as in the Initial auto installation (Analogue). (See page 7.)

Press c/d to select “Setup”.

Press MENU and the MENU screen displays.

1

2

3 Press a/b to select “Auto Installation”, and then press OK.

If you have already set the PIN under “Child Lock”, enter it here.

You can run Auto Installation again, even after setting up the preset channels.

Menu operations

Power Control menu

Power Control

No Signal Off

No Operation Off

Power Management

No Signal Off TV/AV only

Menu Operation: A (page 9)

When set to “Enable” the TV will automatically enter the standby mode if there is no signal input for 15 minutes.

•Five minutes before the TV enters standby mode, the remaining time displays every minute.

NOTE

•When a TV programme finishes, this function may not operate.

•This function is not available in DTV mode.

Setup menu

Setup

Auto Installation

Programme Setup

Child Lock

Input Label

Position

PC Setup

HDMI Audio Select HDMI Auto View

WSS

4:3 Mode

Rotate

Lanugage

Supply Voltage

Reset

No Operation Off

Menu Operation: A (page 9)

When you select the desired time, the TV will automatically enter the standby mode if no operation is performed.

Item

30 min. / 3hr. / Disable

•Five minutes before the TV enters standby mode, the remaining time displays every minute.

Power Management PC only

Menu Operation: A (page 9)

When set, the TV will automatically enter the standby mode.

Item

Off: • No power management

Mode1: • If there is no signal input for 8 minutes, the TV enters the standby mode.

•Even if you start using the PC and the signal inputs again, the TV stays in standby mode.

•The TV turns on again by pressing aon the TV or Bon the remote control unit. (See page 7.)

Mode2: • If there is no signal input for 8 seconds, the TV enters the standby mode.

•When you start using the PC and the signal inputs again, the TV turns on automatically.

•The TV turns on again by pressing aon the TV or Bon the remote control unit. (See page 7.)

CAUTION

•When selecting “Reset” in the Setup menu, all menus will be reset to the factory preset values and “Auto Installation” will activate.

Auto Installation TV only

Programme Setup TV only

This section describes how to set up analogue TV channels manually.

1

2

3 Press a/b to select “Programme Setup”, and then press OK.

If you have already set the PIN under “Child Lock”, enter it here.

• See page 14 for setting PIN.

4 Press a/b to select “Auto Search”, “Manual Adjust”,
“Sort” or “Erase Programme”, and then press OK.
Auto Search
Manual Adjust
Sort	Yes
Erase Programme
	No

12