HOW TO SET THE FACTORY PRESETS

Press and hold down CLEAR on the AVC System while it is in standby mode. Then press POWER on the Display or B on the remote control unit to turn the System on.

All setting items (except TV channel) return to the factory presets.

A

• Running the factory preset operation also clears the password.

You can run the Auto Installation again by using the following steps. 1 Turn on the power of the Display and the AVC System.

2 Press MENU. (Make sure the menu screen displays.)

3 Press bto select “Setup”.

4 Press ENTER.

A

If the password setting screen displays, you need to enter your password.

If you forget your password, refer to HOW TO SET THE FACTORY PRESETS above.

5

6

Press a/bto select “Auto Installation”.

Press ENTER.

“Auto Installation completed.” displays. After that, the screen changes to the TV mode.

The password is

.

A

As a precautionary measure, make a note of your password above, scissor it from this manual, and keep it in a familiar place.

72

Page 73
Image 73
Sharp LC-30HV2M operation manual HOW to SET the Factory Presets