Quick setup for ONCOMMAND users

Label Input

You can assign a label to each input source and channel.

1Press MENU and the MENU screen displays.

2Press c/d to select “PPV TV”.

3Press a/b to select “Label Input”, and then press ENTER.

4Press a/b to select the desired input source, and then press ENTER

5For “INPUT 1” to “INPUT 6”:

1Press a/b/c/d and ENTER to select each character of the new name for the input source.

2Press a/b/c/d to select “END”, and then press ENTER to complete the labeling.

For “TV”:

1 Press c/d to select “Air” or “Cable”, and then press b to move down.

2 Press c/d to select the channel number you want to label, and then press b to move down.

•The channel number is based on the physical number, and it may be different from the displayed channel number specifi ed by the hotel server.

3 Select “Select”, and then press ENTER.

4 Press a/b/c/d and ENTER to select each character of the new name for the channel.

5 Press a/b/c/d to select “END”, and

then press ENTER to complete the labeling.

6Press MENU to exit.

NOTE

•Depending on the system version, you can assign a label using the hotel server.

•When you change the input name for “INPUT 1” through “INPUT 6” in the Label Input setting, the input name you have labeled will not change even if you change the Language setting.

CH Re-Map

Sets the channel order (logical channel) to your preferred order.

1Press MENU and the MENU screen displays

2Press c/d to select “PPV TV”.

3Press a/b to select “CH Re-Map”, and then press ENTER.

4Press a/b to select “CH Set”, and then press

ENTER.

5Press a/b/c/d to select the Logical CH you want to set, and then press ENTER.

6Press a/b to select “ANALOG” , “DIGITAL” or the desired input source, and then press

ENTER.

When you select “ANALOG” or “DIGITAL”, input the channel number by using 0 – 9, and then press ENTER.

•Select “Reset” for resetting the channel to the factory preset value.

•When you input digital channels with a single number after the dot, input 0 after the dot.

(e. g., Channel 22.1):

Press 0s2s2s0s1sENTER

7Repeat the steps 5 and 6 until all desired logical channels are set.

8Press MENU to exit.

NOTE

•For resetting all logical channels to the factory preset values, select “CH Reset All” in step 4, press c/d to select “Yes”, and then press ENTER.

15