Remote Replicator

Storing the settings from the TV

1Connect the TRANSPORT (RJ-11) connector of the Remote Replicator to the TRANSPORT terminal of the TV (TV with the master settings) with the supplied RJ-11 cable.

2Press MEMORY SELECT to select the memory bank.

Storing the settings from the TV (for NXTV users only)

1Press MASTER to turn on the TV in the MASTER mode.

2Press TEACH.

•A message appears, and then disappears in a few seconds.

3Press LEARN.

•When the TV is off, the TV will not respond when LEARN is pressed.

3

Repeat steps 1 to 5 in Storing the settings

from the TV.

 

 

• When you connect the Remote Replicator to the

4

The data transfer process is displayed on the screen.

TV, use the supplied RJ-11 cable, not the cable

connected to the PPV terminal box.

5The DONE indicator lights up and a message is displayed on the screen after the data storage is complete.

Transferring the settings to the TV

1Connect the TRANSPORT (RJ-11) connector of the Remote Replicator to the TRANSPORT terminal of the TV (TV to be cloned) with the supplied RJ-11 cable.

2Press MEMORY SELECT to select the memory bank.

3Press TEACH.

•When the TV is off, the TV will not respond when TEACH is pressed.

Transferring the settings to the TV (for NXTV users only)

1Press MASTER to turn on the TV in the MASTER mode.

2Press TEACH.

•A message appears, and then disappears in a few seconds.

3Repeat steps 1 to 5 in Transferring the settings to the TV.

•When you connect the Remote Replicator to the TV, use the supplied RJ-11 cable, not the cable connected to the PPV terminal box.

4The data transfer process is displayed on the screen.

5The DONE indicator lights up and a message is displayed on the screen after the data transfer is complete.

NOTE

•After performing TEACH while in Normal TV Mode, wait until the power is completely off. To turn the power on again after performing TEACH, wait approximately 15 seconds after the TV enters Standby Mode (dark screen). Then turn the power on.

Configuration memory banks

Three different full TV confi guration setups can be stored in the Remote Replicator simultaneously.

This allows different TV confi gurations to be taught to different TVs without having to perform the learning procedure over again.

1Press MEMORY SELECT.

2Each time you press MEMORY SELECT, the MEMORY SELECT indicator switches between memory banks.

DIAGNOSTICS mode (PPV TV only)

Press DIAGNOSTICS to perform the operational tests as shown below.

—Checks the connection between the TV and the PPV terminal box

—Displays the software version

—Switches to the default channel

NOTE

•When the TV is off, the TV will automatically turn on and display the result of test after pressing DIAGNOSTICS.

•DIAGNOSTICS mode is not available for NXTV users.

•Cannot be used while in Normal TV Mode.

27