Menu operation

 

 

 

 

 

EManual

 

 

 

Timer recording with external

You may enter the necessary information for recording

 

 

devices

manually.

 

1 Select “Manual” instead of “Via EPG” in step 4

ERecorder with AV Link

in Via EPG.

If you use an externally connected recorder with AV

• The station selection screen displays.

Link or a similar system, the TV set and connected

• You may be routed to the “Time and date” entry

screen if the TV does not recognise the current time.

recorder exchange its own station/timer data.

2 Press a/b/c/d to select the station you want

Please consult the operating manual of your recorder

to find out if your recorder is AV Link compatible.

to record from, and then press OK.

In addition use only Euro SCART cables for the

3 Timer list screen appears, outlining each setting

connection between the TV set and recorder.

used for the upcoming recording. Set the

Analogue stations

following settings as necessary. Confirm with

The timer data is transmitted automatically from the TV

OK.

set to the recorder after programming is complete.

1 Recorder: Selection of the recording device.

The recording is then controlled by the recorder

2 Date: Date of recording

and the recorder tuner is used for reception of the

3 Recording time: Time of recording

programme.

4 VPS: Selection of using VPS signal

The recording data is not saved in the timer list of the

5 Recording type: Selection of recording frequency

(once only, Mon-Fri, daily, weekly or serial [if EPG

TV set. Consequently if you want to change or delete

data is available]).

the timer data then you must do so on the recorder.

• A message appears if there is a conflict between two

Digital stations

programmes. Follow the screen prompts and choose

If you want to record digital stations with an externally

the one that has priority.

NOTE

connected recorder, then the DVB tuner is used and

the TV device takes over control of the recorder. Then

• If you use an external recorder without AV Link, you have to

the station on the TV set is locked during the timer

select the recording source in the recorder (e.g. AUX, refer

recording.

to your recorder’s operation manual). In case of recording

ERecorder without AV Link

DVB programmes, the TV’s tuner is used, not the VCR’s

tuner.

If you cannot programme your externally connected

• If you use an external recorder with AV Link, this recording

recorder from the TV set, but it supports AV Link, the

source selection is controlled automatically.

receiver of the TV set is always used.

 

 

AV Link must be switched on on the recorder. Read the

 

Timer list

operating instructions of your recorder.

Here you will find a list of channels already

In addition use only Euro SCART cables for the

programmed for recording. From here, you can

connection between the TV set and recorder.

also change the recording data (GREEN), delete

Analogue and digital stations

programmed recordings completely (YELLOW), or

You can control the recording from the TV set. The

programme a new recording (RED) by pressing the

recorder must be set manually to the AV input to which

assigned colour buttons.

the TV is connected. Then the station on the TV set is

 

locked during the timer recording.

 

Pre- and post record time

If you record a programme without VPS, you can specify a time span by which your programme time should be brought forward/prolonged so that programmes which begin/end too early/late are recorded from start to finish.

Copy protection

Copy-protected programs will not be output on the EURO SCART sockets for legal reasons.

34

Page 36
Image 36
Sharp LC-52HD1E, LC-46HD1E operation manual Timer recording with external, Devices