Instructions for attaching a VESA compliant arm
English
An arm or stand based on the VESA standard (purchased separately) can be attached to the monitor.
Procurement of the arm or stand is at the custom- er's discretion.
Arms or stands able to be used Attachments must satisfy the following.
-Compatible with the VESA standard
-Have a gap of 100 mm x 100 mm between the screw holes on the section to be attached
-Not be likely to fall off or break off after being attached to the monitor.
4. Remove the two screws, and remove the cover.
Cover
Two screws
5. Remove the four screws and then remove the stand from the monitor.
Four screws
How to attach the arm or stand
CAUTION!
Be careful not to cut or jam your fingers.
Note:
-Do not bend the signal cable or the AC adapter cable nor place weight on them. Doing so could lead to damage.
-While following these instructions, please also refer to the installation instructions in the operation manual included with the arm or stand
1.Spread out a soft cloth on a suitable horizontal surface.
2.Being careful not to damage the monitor, gently lay the monitor on it
3.Remove the stand cover and the covers to the left and to the right.
(Rear view) | Stand cover |
| |
Cover | Cover |
| |
| Lift one side |
Stand
6.Attach the arm to the monitor with the four screws.
The screws used to attach the arm should be M4 screws with a length of 8 mm ~ 10 mm protruding from the surface to be attached.
Using different screws could lead to malfunction or may lead to the monitor falling off,internal damaged,personal injury
Screw used to attach arm
Arm
Part of monitor to which arm is attached
29
