Sharp LL-T1811W Adjusting the screen display when using an analog signal, ADJUSTMENT Menu, Clock

Adjusting the screen display (when using an analog signal)

Manual screen adjustment

Adjustments can be made using On Screen Display (OSD) Menu provided.

1.Display an image that makes the entire screen very bright. If using Windows, you can open and use the Adjustment Pattern on the accompanying Utility Disk. (p. 19)

2.Press the MENU button.

The ADJUSTMENT Menu will be displayed.

At this point relevant menu options can be adjusted.

Each time the MENU button is pressed the next menu is selected. (ADJUSTMENT → GAIN CONTROL → WHITE BALANCE → MODE SELECT → OSD Menu disappears)

Notes:

-The OSD Menu automatically disappears approximately 30 seconds after the last command.

-This explanation is based on using the Adjustment Pattern (for Windows) to make adjustments.

ADJUSTMENT Menu

MANUAL: Individual menu options are manually adjusted.

AUTO: Every menu option is automatically adjusted.

Notes:

-Press the button to select [AUTO].

-To choose a menu option: SELECT button

-To go to the next menu: MENU button

CLOCK

The figure below demonstrates how to adjust so that

vertical flicker noise is not emitted. ( buttons)

Vertical flicker noise

PHASE

The figure below demonstrates how to adjust so that

horizontal flicker noise is not emitted. ( buttons)

Note:

-Adjustments to PHASE should be made only after CLOCK has been correctly set.

Horizontal flicker noise

H-POS (horizontal positioning) and V-POS (vertical positioning)

To center the screen image within the boundaries of the screen, adjust the left-right (H-POS) values and

the up-down (V-POS) values. ( buttons)

Screen frame

20