Sharp MD-M1H operation manual Setting the Clock, To see the time display, To change the clock time

SETTING THE CLOCK

In this example, the clock is set for the 24-hour (0:00) system.

2

4,6,8 3,5,7,9

1

1 Press the ON/STAND-BY button to turn the power on.

2 Press the CLOCK button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

3 Within 5 seconds, press the ENTER button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

4 Press the or button to select the time display mode.

DISC TOC

TRACK

MEMORY

RANDOM

TOTAL

REMAIN

"0:00" →The 24-hour display will appear. (0:00 - 23:59)

"12:00 AM" →The 12-hour display will appear. (AM or PM 12:00 - 11:59)

"0:00 AM" →The 12-hour display will appear. (AM or PM 0:00 - 11:59)

●Note that this can only be set when the unit is first installed or it has been reset (see page 48).

5 Press the ENTER button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

6 Adjust the hour by pressing the or button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

●When the button is pressed once, the time will increase by 1 hour.When the button is pressed once, the time will decrease by 1 hour.

●When the 12-hour display selected, “ AM ” will change to “ PM ” automatically.

7Press the ENTER button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

8 Adjust the minutes by pressing the or button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

●When the button is pressed once , the time will increase by 1 minute. When the button is pressed once, the time will decrease by 1 minute.

●The hour setting will not advance even if min- utes advance from "59" to "00".

9 Press the ENTER button.

DISC TOC
TRACK
MEMORY
RANDOM	kHz REC
TOTAL
REMAIN	MHz SLEEP

●The clock starts operating from "0" seconds. (Seconds are not displayed.)

To see the time display:

Press the CLOCK button.

●The time display will appear for about 5 seconds even if stand-by mode.

Note:

●The clock display will flash on and off at the push of the CLOCK button when the AC power supply is restored after a power failure occurs or after the AC power lead is disconnected.

If this happens, follow the procedure below to change the clock time.

To change the clock time:

1Press the CLOCK button.

2Within 5 seconds, press the ENTER button.

3Perform steps 6 - 9 above.

To change the time display mode:

1Reset the microcomputer (see page 48).

2Perform steps 1 - 9 above.

9