Sharp MD-M1H operation manual Special Notes, Service Information

SPECIAL NOTES

NOTE FOR USERS IN THE U.K.

The mains lead of this product is fitted with a non- rewireable (moulded) plug incorporating a 3A fuse. Should the fuse need to be replaced, a BSI or ASTA approved BS 1362 fuse marked or and of the same rating as above, which is also indicated on the pin face of the plug must be used.

Always refit the fuse cover after replacing the fuse. Never use the plug without the fuse cover fitted.

In the unlikely event of the socket outlet in your home not being compatible with the plug supplied, cut-off the mains plug and fit an appropriate type.

DANGER:

Ensure that neither the brown nor the blue wire is connected to the earth terminal in your three pin plug.

Before replacing the plug cover, make sure that:

●If the new fitted plug contains a fuse, its value is the same as that removed from the cut-off plug.

●The cord grip is clamped over the sheath of the mains lead and not simply over the lead wires.

IF YOU HAVE ANY DOUBT, CONSULT A QUALI- FIED ELECTRICIAN.

The fuse from the cut-off plug should be removed and the cut-off plug destroyed immediately and disposed of in a safe manner.

Under no circumstances should the cut-off plug be inserted elsewhere into a 13A socket outlet as a serious electric shock may occur.

To fit an appropriate plug to the mains lead, follow the instructions below:

IMPORTANT:

The wires in the mains lead are coloured in ac- cordance with the following code:

Blue : Neutral

SERVICE INFORMATION

In the unlikely event of your equipment requiring repair, please contact the dealer or supplier from whom it was purchased. Where this is not possi- ble, please contact the telephone number listed below.

You will then be given details of how to obtain serv- ice.

- 0345-125387 -

Please note; all calls will be charged at local rate.

Certain replacement parts and accessories may be obtained from our main parts distributor.

Brown : Live	WILLOW VALE ELECTRONICS LTD.
As the colours of the wires in the mains lead of	MANCHESTER	0161-682-1415
this product may not correspond with the coloured	READING	01189-876444
markings identifying the terminals in your plug,
proceed as follows:	In the unlikely event of this equipment requiring
● The wire which is coloured blue must be con-	repair during the guarantee period, you will need
nected to the plug terminal which is marked N	to provide proof of the date of purchase to the
or coloured black.	repairing company.
● The wire which is coloured brown must be con-	Please keep your invoice or receipt, which is sup-
nected to the plug terminal which is marked L	plied at the time of purchase.
or coloured red.
● Recording and playback of any material may re-	● US and foreign patents licensed from Dolby Labo-
quire consent, which SHARP is unable to give.	ratories Licensing Corporation.
Please refer particularly to the provisions of the
Copyright Act 1956, the Dramatic and Musical
Performers Protection Act 1958, the Performers
Protection Acts 1963 and 1972 and to any sub-
sequent statutory enactments and orders.
● This equipment complies with the requirements
of Directives 89/336/EEC and 73/23/EEC as
amended by 93/68/EEC.
● When the ON/STAND-BY button is set at STAND-
BY position, mains voltage is still present inside
the unit.
When the ON/STAND-BY button is set at STAND-
BY position, the unit may be brought into opera-
tion by the timer mode or remote control.	CAUTION
Warning:
	Use the MD micro system only in accordance with
This unit contains no user serviceable parts. Never
	the instructions given in this manual and do not at-
remove covers unless qualified to do so. This unit	tempt to interfere with the interlock switch or make
contains dangerous voltages, always remove mains	any other adjustment as this may result in expo-
plug from the socket before any service operation	sure to hazardous radiation.
and when not in use for a long period.

1