Sharp MD-MT821 manual After recording, To remove the MiniDisc, To interrupt recording

After recording:

Press the n /:OFF button while in the stop mode.

0After the track number has been written on the disc, the power will shut off auto- matically. (For details about the TOC, see page 20.)

To remove the MiniDisc:

Turn off the power and move the OPEN lever in the direction indicated by the arrow.

0

W Recording from a tuner or a CD (Manual recording)

0 Manual recordings can be started and stopped as you like.

1 Place the unit in the recording stand-by mode. (Perform steps 1 -- 4 in the “Syn- chro recording” section.)

2 Press the )I1 button.

0 Recording will start.

0 To record from a CD, press the )I1 button, and then start playback on the equipment connected to this unit.

0 Track numbers can be created while recording. (Page 17)

To interrupt recording:

Press the )II button while recording.

0 The unit will enter the recording stand- by mode.

0 To resume recording, press the HI but- ton again.

The track number will be increased by one each time you interrupt a record- ing.

Recordings can not be made in the following situations:

B Recording on a playback-only MiniDisc (commercially available music)

D If a MiniDisc is protected against acci- dental erasure (page 9)

about the recording level:

BIf the recording level is too low, the play- back sound volume may be too low to hear well. If it is too high, the playback sound may be greatly distorted. Since digitally recorded CDs have a large dy- namic range (the volume can vary tre- mendously from very soft to extremely loud), do not set the recording level any higher than is necessary.

Precautions when recording:

B Do not jar or bump the main unit while recording. Otherwise, the recording may be unusable.

0 Depending on the strength and type 01 playback signal in the original record- ing, the new recording may not begin or pause at the correct point when in the synchro mode. If this happens, try making a manual recording.

Precautions when inserting a MiniDisc:

0To insert a MiniDisc, push on the middle of the edge of the disc while holding it parallel to the main unit.

0 If any resistance is felt, do not try to force the MiniDisc into the unit. It may additional more problems. If resistance is felt, remove the MiniDisc and try re- loading it.

Notes:

•Whenever any button is pressed, the remote control display will light for ap proximately 7 seconds.

0 The REC button does not light.

11