Sharp MD-MT821 manual Sys

E r r o r m e s s a g e s			M e a n i n g		R e m e d y
B a t t	EMPTY	• The battery run down.		• Charge the rechargeable battery or
					replace the alkaline battery (or use the
(Lo BAT-T)
					AC adaptor for p o w e r
BLANK DISC		•	Nothing is recorded.	•	Replace the disc with a recorded disc.
( B L A N K )
Can’t COPY		•	No copy can be made because of the	•	Record using the analog cable.
(Not	REC)		SCMS copyright system.
Can’t	EDIT	•	A track cannot be edited	•	Change the stop position of the track
					and then try editing It.
Can’t	REC	•	Recording cannot be performed	•	Re-record or replace It with another
			correctly due to vibration or shock in		recordable disc
(Not	REC)
			the unit
Can’t	WRITE	•	Editing is impossible.	• Check the number of tracks.
D E F E C T		• The disc is scratched.		• If the sound you hear is not right, try
					recording again
(DEFECT)				•	replace the disc with another
					recordable d i s c
Din UNLOCK		•	Poor connection of the digital cable.	•	Connect the digital cable securely.
( U N L O C K )
DISC	FULL	•	The disc IS out of recording space.	•	Replace it with another recordable disc.

POWER ?	•	Improper power is being supplied.	•	Use one of the specified power
				sources.
	• The MD is write protected.		•	Move the write protection knob back to
	• You tried to record without loading an			its original position.
P R O T E C T E D		MD.	•	Load a recordable MD.
	• A playback-only MD was loaded and		•	Replace it with a recordable MD.
		the REC button was pressed when the
		Power was off.
READ ERROR •		The disc is damaged.	•	Reload the disc or replace It.
			•	Replace it with another recorded disc

•Since a track number is currently being • Wait for a while and try the operation located or written to, the unit cannot

	STEM ERR		•	You have come to the conclusion that			• To have it repaired, go to the distributor
	(E-SYS)			the unit is out of order.				where you purchased the unit.
	EMP OVER		•	The temperature is too high.			•	Turn off the power, and wait for a while.
;E-TEMP)
TOC		ERROR	•	A large portion of the disc has been			•	Replace it with another recorded disc.
	(E-TOC)			damaged.
					c e	IV, “u”‘““‘y		replace it with another recordable disc
					ation	(track names,
					e e c t .
Tr. Protect			•	The trac k has been protected from			•	edit the track with the device on which
				being erased				it w a s recorded
								.
TOC		ERROR	•	A large portion of the disc has been			•	Replace it with another recorde d d i s c
(E-UTOC)				damaged.			w erase all of the signal errors, and then
			•	There is an error in the recorded signal				try recording again
	? DISC		•	Adiscn which contains data other than			•	A disc which contains non-music data
				music was played				c a n	be played
	(?DISC)		•	There is an e r r or the signal from the			•	Re place	it with another recorded disc.
				disc.

( ): Error messages seen on the remote control.

39