nRecording from the microphone (Mic synchro recording)
The recording will begin automatically in response to a noise or a person speaking. When the sound stops, the recording will pause. This function is convenient when recording lectures, conferences, etc.
Stereo microphone (commercially available)
To the MIC IN jack |
|
|
1 Connect the stereo microphone to the | 5 Press the ENTER/SYNC button to se- | |
MIC IN jack on the main unit. | lect the synchro recording level. (This | |
0 When a microphone is connected to | level can be changed, even while re- | |
this unit, the unit will automatically | cording.) | |
switch to input from the microphone. | 0 Refer to the following table. | |
2 Insert a recordable MiniDisc. |
|
|
|
| |
I | I | Synchro | Sound level at which | ||
(See page 10.) | recording level | ||||
to start recording | |||||
| display | ||||
3 Press the REC button. |
| ||||
|
| ||||
|
|
|
| ||
0 A monaural, |
|
|
|
| |
is available. (Page 17) |
|
|
|
| |
0 Timed identification marks can be cre- |
|
|
|
| |
ated while recording. (Page 15) |
|
|
|
|
4 Move the t++ REC LEVEL w shuttle switch to adjust the recording level.
OdB
0 Adjust the recording level so that the maximum sound volume from the source makes the reading swing be- tween
0 When the recording level display is changed from “MIC H 21” to “MIC L 20”, the sound will be interrupted mo- mentarily.
This is normal.
0 When the microphone input is set to “MICSYNC H”, recording will start when the smallest noise is detected. If the unit starts recording too often from small unwanted noises, set the microphone input to “MIC SYNC L”.
13
