Sharp Version 2.5 RightFax Server Support and Requirements, Sharp MFP Support and Requirements

RightFax Server Support and Requirements

All RightFax servers that will be used for sending faxes from Sharp devices must be version 9.0 or higher. Microsoft Internet Explorer version 6 is required on all RightFax servers.

The repository folder where outbound faxes originating from the Sharp device will be placed must be configured as an FTP site on an IIS server on your network. Before you begin, ensure that the FTP component is installed on the IIS server you want to use. You should also add a subfolder called Sharp under the \Inetpub\ftproot folder on the IIS server. This will be used as the repository folder.

If you are upgrading from an earlier version of the External Document Connector

Installing the RightFax MFP Module will overwrite all earlier versions of the RightFax External Document Connector (EDC) for Sharp extensions, discarding any existing configuration settings. Captaris strongly recommends that you write down or take screenshots of the existing configuration settings before installing the RightFax MFP Module. Many of these settings will be reused with the RightFax MFP module and information about your existing EDC settings will simplify the process of configuring the new module.

RightFax MFP Module 2.5 Guide for the Sharp Extension 10

Sharp MFP Support and Requirements

The RightFax MFP Module supports the following Sharp models:

￿AR-M350N

￿AR-M450N

￿AR-M550N

￿AR-M620N

￿AR-M700N

Important Your Sharp device includes configuration software can be accessed via a Web browser. To access this software, you must know the IP address of the Sharp device. If you have not already set up the Sharp device so that this software is accessible you should do so now.

Install the RightFax MFP Module

To install the RightFax MFP Module, you must complete the following steps:

1.Download the RightFax MFP Module (described on page 11)

2.Run the RightFax MFP Module installation (described on page 11)

The MFP Module installation program copies the module’s files to the RightFax server and lets you configure some of the settings required to integrate RightFax with your Sharp MFPs.

Important information about installations and upgrades

Do not re-run this installation if you have already installed this version of the MFP Module or if you have installed any other RightFax products which use the same installation architecture as this product. Doing so will detect the existing installation and offer the options Repair and Uninstall. Selecting Repair will cause any existing configuration settings to be overwritten with default settings. If you have already installed this product or any of the