Setup Connections&
Power ON/OFF
| Press POWER ON on the projector or |
| POWER on the GyroRemote. |
| • The flashing green LAMP REPLACEMENT indicator |
| shows that the lamp is warming up. Wait until the |
| indicator stops flashing before operating the projector. |
POWER | • If the power is turned off and then immediately turned |
| on again, it may take a short while before the lamp |
| turns on. |
| • When the projector cannot recognize GyroRemote, an on- |
| screen display appears. Follow the instructions to activate |
| control. |
| • After the projector is unpacked and turned on for the first |
| time, a slight odor may be emitted from the exhaust vent. |
| This odor will soon disappear with use. |
LAMP REPLACEMENT indicator
On-screen Display
When the power is on, the LAMP REPLACEMENT indicator lights, indicating the status of the lamp. Green: Lamp is ready.
Flashing green: Warming up.
Red: Change the lamp.
Press POWER OFF on the projector or POWER on the GyroRemote.
Press POWER OFF/POWER again while the message is displayed.
•If you accidentally pressed POWER OFF/POWER and do not want to turn off the power, wait until the power off screen disappears.
•When the power is turned off, the POWER indicator will light up red and the cooling fan will run for about 90 seconds. The projector will then enter standby mode.
•Wait until the cooling fan stops before disconnecting the power cord.
•The power can be turned on again by pressing POWER ON/POWER. When the power is turned on, the POWER indicator and the LAMP REPLACEMENT indicator light green.
•The POWER indicator flashes if the bottom filter cover is not securely installed.
