Replacing the Air Filter
•This projector is equipped with two air filters to ensure the optimal operating condition of the projector.
•The air filters should be cleaned every 100 hours of use. Clean the filters more often when the projector is used in a dusty or smoky location.
•Have your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center exchange the filter (PFILD0080CEZZ) when it is no longer possible to clean it.
Bottom View | Side and Rear View |
Air filter | Air filter (not removable) |
Cleaning and replacing the bottom air filter
Turn off the power and | Remove the bottom | 3 | Remove the air filter. |
1 disconnect the power | 2 filter cover. |
| |
cord. |
|
|
|
Press POWER OFF. Wait until | Turn over the projector. Press the | Grasp the air filter between your | |
the cooling fan stops. | tab and lift open the filter cover | fingers and lift it out of the filter | |
Push the antenna completely | in the direction of the arrow. | cover. | |
down to its resting position. |
|
|
|
| Tab |
|
|
4 Clean the air filter. | 5 Replace the air filter. | 6 cover.Replace the filter |
Clean the dust off the air filter | Place the air filter underneath | Insert the tab on the end of the |
and cover with a vacuum | the tabs on the filter frame. | filter cover into the filter cover |
cleaner extension hose. |
| opening and press the filter |
|
| cover into position. |
|
| Tab |
•Be sure the filter cover is securely installed. The power will not turn on unless it is correctly installed.
Troubleshooting | Maintenance& |
|
|
Cleaning the side air filter (not removable)
If dust or dirt has collected inside the air filter, clean the filter with a vacuum cleaner extension hose.
•The side air filter cannot be removed.
