Using GyroRemote
Antenna 
Preparation
1 Switch on the projector power source. The projector image will appear on the screen.
2 Pull out the projector antenna.
•The control range will not be optimized if you do not pull out the antenna. Always use with the antenna fully extended.
•The control range under actual operating conditions may be less than optimum depending on where the projector is placed and the radio signal environment.
3 Press POWER on the GyroRemote, located on the front, inside the upper cover.
•The GYRO RF indicator on the projector flashes green whenever it receives a radio signal from the GyroRemote.
Operating the screen pointer
1 Press POINTER on the GyroRemote.
As the POINTER is being pushed, a pointer on the screen will display. If you release your finger from the POINTER it will disappear from the screen.
2 Hold the GyroRemote and move it around freely in the air. The pointer on the screen moves precisely in concert with the movement of your GyroRemote in hand.
Menu Adjustments
1 Open the upper cover on the front of the GyroRemote.
2 Press MENU.
3 Press GYRO ACTIVE on the back of the
Operation Buttons
GyroRemote, and select your desired category by moving the unit left or right.
4 Then select the desired item by moving the unit up or down.
5 Move the unit left or right, or press / to adjust item values.
6 Press MENU.
The menu display disappears.
•Double click on GYRO ACTIVE, the LED will light and you can operate GyroRemote just like pressing the button continuously. To cancel this mode, press GYRO ACTIVE once.
•If you release GYRO ACTIVE located on the back of the unit, you will not be able to control operations no matter how you wave your hand in the air.
