Sharp XG-P20XU operation manual Important Safeguards, Projector

Important Information

IMPORTANT SAFEGUARDS

LAMP REPLACEMENT

CAUTION

BEFORE REMOVING THE SCREW, DISCONNECT

POWER CORD. HOT SURFACE INSIDE

ALLOW 1 HOUR TO COOL BEFORE REPLACING

THE LAMP. REPLACE WITH SAME SHARP LAMP

UNIT TYPE BQC-XGP20X//1 ONLY.

UV RADIATION : CAN CAUSE EYE DAMAGE.

TURN OFF LAMP BEFORE SERVICING.

MEDIUM PRESSURE LAMP : RISK OF EXPLOSION.

POTENTIAL HAZARD OF GLASS PARTICLES IF

LAMP HAS RUPTURED. HANDLE WITH CARE.

SEE OPERATION MANUAL.

Caution Concerning the Lamp Replacement

See “Replacing the Lamp” on pages 68 and 69 .

PRODUCT DISPOSAL

This product utilizes tin-lead solder, and high intensity discharge lamp (HID lamp) containing a small amount of mercury. Disposal of these materials may be regulated due to environmental considerations. For disposal or recycling information, please contact your local authorities or the Electronics Industries Alliance: www.eiae.org.

Caution Concerning the Lamp Unit

Potential hazard of glass particles if lamp ruptures. In case of lamp rupture, contact your nearest Authorized Sharp Industrial LCD Products Dealer or Service Center for a replacement.

See “Replacing the Lamp” on pages 68 and 69 .

	Cautions Concerning the Setup of
	the Projector
	For minimal servicing and to maintain high image quality,
	SHARP recommends that this projector be installed in
	an area free from humidity, dust and cigarette smoke.
	When the projector is subjected to these environments,
	the lens must be cleaned more often. As long as the
CAUTION	projector is properly maintained in this manner, use in
	these environments will not reduce the overall operation
PRECAUCIÓN	life. Please note that all internal cleaning must be
PRÉCAUTION	performed by an Authorized Sharp Industrial LCD
	Products Dealer or Service Center.

Notes on Operation

• The exhaust vent, the lamp cage cover and adjacent areas may be extremely hot during projector operation. To prevent injury, do not touch these areas until they have sufficiently cooled.

• Allow at least 4 inches (10 cm) of space between the exhaust vent and the nearest wall or obstruction.

• If the cooling fan becomes obstructed, a protection device will automatically turn off the projector lamp. This does not indicate a malfunction. Remove the projector power cord from the wall outlet and wait at least 10 minutes. Then turn on the power by plugging the power cord back in. This will return the projector to the normal operating condition.

E-3