Basic Operations
Projector | Remote control |
5 Press INPUT on the projector, INPUT 1, INPUT 2, |
|
| ON/OFF | LAMP |
|
POWER |
|
| |
|
|
| |
|
| TEMP. |
|
| KEYSTONE |
| |
INPUT |
| PICT MODE |
|
BACK |
| ENTER | MENU |
8 | VOL | |
6 | ||
POWER | ||
|
MUTE | BACK | |
7 | ||
MENU | ||
5 | ENTER | |
| RGB/ | |
INPUT 1 | COMPONENT PICT MODE | |
INPUT 2 AUTO SYNC GAMMA | ||
CLR TEMP | ||
VIDEO | KEYSTONE FREEZE | |
the desired input mode. |
Press INPUT, INPUT 1, INPUT 2, |
VIDEO again to change the mode. |
• When the selected input signal is being received, “Adjusting |
The Image” will be displayed. |
• When no signal is being received, “NO SIGNAL” will be |
displayed. When a signal that the projector is not preset to |
receive is being received, “NOT REG.” will be displayed. |
6Press VOLUME on the remote control to adjust the volume.
7Press MUTE on the remote control to temporarily turn off the sound.
Press MUTE again to turn the sound back on.
EXAMPLE 
5INPUT 1 Mode | INPUT 2 Mode |
8 Press ON/OFF on the projector for over one |
second, or POWER on the remote control. |
Press ON/OFF or POWER again while the |
message is displayed. |
Operation
d
VIDEO Mode
g
f
s
• If you accidentally pressed ON/OFF or POWER and do not |
want to turn off the power, wait until the power off screen |
disappears. |
• When ON/OFF or POWER is pressed twice, the POWER |
indicator will light up red and the cooling fan will run for |
about 90 seconds. The projector will then enter standby |
mode. |
• Wait until the cooling fan stops before disconnecting the |
power cord. |
• The power can be turned on again by pressing ON/OFF or |
POWER. When the power is turned on, the POWER indicator |
6
7
8
and the LAMP REPLACEMENT indicator light green. |
• The POWER indicator flashes if the right side filter cover is |
not securely installed. |
WARNING:
The cooling fan in this projector continues to run for about 90 seconds after the projector is turned off. During normal operation, when turning the power off always use the ON/ OFF button on the projector or the POWER button on the remote control. Ensure the cooling fan has stopped before disconnecting the power cord.
DURING NORMAL OPERATION, NEVER TURN THE PROJECTOR OFF BY DISCONNECTING THE POWER CORD. FAILURE TO OBSERVE THIS WILL RESULT IN PREMATURE LAMP FAILURE.
16
