Assembly
This unit comes fully assembled with the exception of the handlebar, cutting attach- ment shield and cutting attachment.
IMPORTANT!
The terms “left”,
Handlebar
Prior to Assembly
Before assembling, make sure you have all the components required for a complete unit and inspect unit and compo- nents for any damage.
ŶEngine/Outer tube assembly
ŶHandlebar and Throttle assembly
ŶCutting attachment shield
ŶCutting attachment
ŶKit containing cutting attachment shield mounting bracket and hardware, this owner’s/operator’s manual and tool kit for routine maintenance. Tool kits vary by model and may include a hex wrench, and a spark plug/screwdriver combination wrench.
Install the handlebar:
1.Use the 4 mm hex wrench to remove the lower cap retaining screws from the handlebar bracket. Remove the cap from the bracket, and note the position of the two spacers installed between the bracket halves.
2.Position the handle on the outer tube forward of Handle Positioning Label as shown. Reassemble the lower cap to the handlebar bracket in the reverse order of disassembly.
3.Locate the handle in the best position for operator comfort.
4.Firmly tighten both lower cap retaining screws.
Strap |
Hanger |
Handlebar |
Outer Tube |
Handle Positioning Label |
Lower cap |
Lower Cap |
Retaining Screws |
Mounting the brushcutter handlebar |
Adjust throttle lever free play
The throttle lever free play should be approximately
1.Loosen the air cleaner cover knob and remove the air cleaner cover.
2.Loosen the lock nut on the cable adjuster.
3.Turn the cable adjuster in or out as required to obtain proper free play.
4.Tighten the locknut.
5.Reinstall the air cleaner cover.
Throttle lever free play | Remove air cleaner cover |
|
Cable Lock
Adjuster Nut
Adjust as required to obtail
6
