Shindaiwa DG1000MI Fuel Line Changeover Valve 3-way valve, Using fuel from built-in fuel tank

5.2.8.2 Throttle Lever

Throttle Lever

The lever is to adjust the engine speed.

Set it to

IDLING

when the engine starts and

FIXING SCREW NUT

warms-up or cools down.

When the rated power is used, set it to RUN

THROTTLE LEVER

(50 or 60Hz).

FREQUENCY ADJUSTING SCREW

Frequency Adjusting Screw

①Set the throttle lever to

RUN

and loosen the fixing

Screw nut.

Turn the screw to

HIGH

to get high frequency and

＜

＞

＜

＞

to

LOW

to low frequency.

<Caution>

￿ The equipment is set it at 50Hz and delivered.

②

＜

＞

Re-set it to 60Hz according to the above procedure

＜

＞

￿ You can get the frequency of 50Hz or 60Hz under the rated output load in case

adjusting it as per the following frequency under no＜load.

＞

No-load frequency(Revolution)

50Hz Operation

52.5Hz

1575min-1

60Hz Operation

63.0Hz（1890min-1）

5.3 Fuel Line Changeover Valve (3-way valve)

Caution

:Burns

￿Always stop the engine when performing any work on the fuel line.

￿Always wipe any drip of Diesel fuel or engine oil. Do not use this equipment, when leak is found. Repair the equipment before use.

By switching the 3-way valve, you can use fuel from external fuel tank.

In this case, the Diesel fuel in the built-in tank will not be used.

5.3.1 Using fuel from built-in fuel tank

The lever for 3-way valve is set to A when the equipment is shipped. In addition, both the external fuel intake and the external fuel return are safeguarded with PT-1/2 plugs. Do not remove the plugs, when using the built-in fuel tank.

- 16 -