Shindaiwa DG1000MI ① ② ③ ④, Draining Water from Water Separator, Cleaning / Changing Fuel Filter

10.4Draining Water from Water Separator

When a float (red) is at drain level, drain water. Loosen the drain plug and drain water.

②	Screw the drain plug, when finishing drain.
<Caution>
￿ After draining finishes, extract the air in fuel line.
①	(Refer to 9-3 During operation.)

10.5 Cleaning / Changing Fuel Filter

Clean Replace

Every 200 hours Every 500 hours

①

②

③

④

Loosen and remove the fuel filter, using an oil filter wrench

Drain all the water in the fuel filter

Smear a little fuel on the rubber gasket of the new fuel filter

Screw the new filter into place and tighten it until the gasket contacts the seat. Then, give it additional 2/3 turn to seat the filter, using an oil filter wrench

<Caution>

￿After replacing the filter, always air out the fuel system (refer to 9-2. During Operation)

￿Fuel filter element:

ISUZU Part No.

1132400791

- 42 -