Shindaiwa DG1000MI manual 10.1, Oil Change, replace, refer to 8-1 Checking Engine Oil

10.1		Oil Change
			First time		50 hour mark
			From second time		Every 200 hours
①		Remove Oil Filler cap				OIL FILLER
		Loosen the engine oil drain plug and allow the oil to
		drain fully
		Reinstall the drain plug
		Add oil from oil filler and fill up to the MAX level.
		You should check the oil level on the oil gauge
		Reinstall the filler cap hand-tight
<Caution>
②		For the types of engine oil to use and volume to
	￿
③		replace, refer to 8-1 Checking Engine Oil
④
10.2⑤Oil Filter Change
	First time			50 hour mark
	From second time			Every 400 hours
①		Drain the engine oil fully, as described in 10.1
		Loosen and remove the oil filter, using an oil filter wrench
		Smear a little engine oil on the rubber gasket of the new oil
		filter
		Screw the new filter into place and tighten it by hand until the
		gasket contacts the seat. Then, give it additional 3/4 - 1 turn
		to seat the filter, using an oil filter wrench
②		Add oil and install filler cap
③
<Caution>
	￿ If an oil filter wrench is not available, contact our authorized
④		distributor or our engineering section.
	￿	Oil filter
⑤
					ISUZU Part No.
					1132402321

- 40 -

OIL FILLER CAP

OIL GAUGE

OIL DRAIN PLUG