Shindaiwa DG1000MI manual Stopping the Generator, Protection Features, Feature List

:Fire

Caution

		￿ Always wipe any drip of gasoline or oil.
				Add fuel to the fuel tank
				Turn the starter switch to <RUN> position. It will take approximately 30 seconds to
				vacuum the air out.
	<Caution>
		￿ Ensure that all the air is completely extracted from fuel line, by setting the throttle lever
		①	to IDLING and start the engine. In the case air is in the fuel line, the engine speeds is
9.4			unstable, and proceed with the vacuuming steps again.
	Stopping the Generator
		②
				Turn the switch and the circuit breaker for the load equipment to OFF
				Turn the circuit breaker for single-phase and 3-phase on the control panel to OFF
				position
				Set the throttle lever to IDLING
				Keep the engine idle (cooling down) for at least 3 minutes
				Turn the starter switch to STOP position
9.5	Protection Features
		①
	This generator is equipped with automatic shutdown feature and display of the location of alarm,
		②
	in event of any alarm situation. In event of the automatic shutdown or alarm lamp flashing, turn
	off the engine and investigate the alarm.
		③
		Protection④			Feature List
		⑤
								Action
		No.		Symptoms			Circuit	Automatic	Alarm	Cause
							Breaker	Engine	Lamp
							OFF	Shutoff	Flash
				High Coolant						Engine coolant temperature
		1					--			is too high
				temperature
										(default at 105 degrees Celsius)
				Oil	pressure					Engine oil pressure dropped
		2					--			(default at 0.98 x 100kPa)
				drop						2
										(1.0kg/cm )
				Insufficient						When the battery can no longer
		3		battery			--	--		hold charge
				charge
				Current						When current leaks to the earth
		4		leaks to		the		--
				earth
		5		Overload				--	--	When the circuit overloads
								○
		indicate the automatic feature							○
							○	- 36 -