Siemens 5890 manual Point-to-Point Protocol over ATM LLC Encapsulation

SIEMENS 5890 DSL Router	Chapter 3 Easy Setup
User’s Guide	Select Protocol

Point-to-Point Protocol over ATM (LLC Encapsulation)

If you selected Point-to-Point Protocol over ATM (LLC Encapsulation) from the Wan Interface page, the Point-to-Point Protocol page is displayed when you click Next.

To configure Point-to-Point Protocol:

1.Enter PPP User Name and Password to use for authentication when establishing a WAN connection using

PPPprotocol.

2.Select one or more of the following PPP Networking options:

• Bridging Enabled:

Forward all traffic for remote hosts that is not routed to the WAN (non-IP). If bridging is enabled, you can optionally select Only bridge PPPoE traffic. If selected, only PPPoE traffic is bridged; all other traffic is stopped.

3.IP Routing Enabled:

Route all IP traffic to remote hosts.

4.If you enabled IP routing, select one of the following methods for configuring IP routing:

• Obtain configuration automatically from WAN IP routing parameters are obtained from the WAN.

• Configure IP Routing manually

IP routing parameters are set manually. If you select this options, you must the Source WAN IP Address, Subnet Mask, and Default Gateway.

SIEMENS 20