Siemens HG2425UC, HG2528UC manual Self Clean, Remove Racks, Cleaning Guidelines

Models: HG2528UC HG2425UC

1 52
Download 52 pages 41.19 Kb
Page 43
Image 43
Setting the Self-Clean Mode

Setting the Self-Clean Mode

Delaying the Start of the Self-Clean

Cleaning and Maintenance

Do hand-clean 1 1/2 inches from rack guides to front of oven cavity.

Do not hand-clean the gasket.

Do hand-clean frame area outside the gasket.

Do hand-clean door area outside the gasket.

Figure 4: Cleaning Guidelines

5.Review illustration above. Some areas of the oven must be cleaned by hand before the cycle begins. Use a soapy sponge or plastic scrubber or a deter- gent-filled S.O.S.® pad. Hand-clean the oven door edge, oven front frame and up to 1-1/2 inches inside the frame with detergent and hot water. Do not clean or rub the gasket on the oven. The gasket is designed to hold in heat during the self-clean cycle. Rinse all areas thoroughly then dry.

6.Be sure oven light is turned off and the light bulbs and lens covers are in place. Do not operate oven without light bulb and cover in place.

Important: Do not use Commercial Oven Cleaners on the self-clean oven or any part because they will damage the finish or part.

1.Press COOKING MODE.

2.Turn knob until SELF CLEAN mode appears. Press START.

3.The default cleaning time is 4 hours. To

change cleaning time, turn knob to change

3: 00

SELF CLEAN

number of hours. Otherwise, continue to

 

 

3

step 4.

 

4.Press START. SELF CLEAN flashes. Press

START.

5.REMOVE RACKS appears in the display

as a reminder to remove oven racks.

SELF CLEAN

6. Press START again to begin the self-

4: 00

REMOVE RACKS

clean.

Note: The door locks at the beginning of the

cycle; The door lock symbol will appear in the display at this point. If door does not lock, press OFF and do not self-clean; phone service.

Note: The time of day must be correctly set for this option to work properly. See section “Setting the Clock” in “Setting Up Your Range”.

1.Press COOKING MODE.

2.Turn knob until SELF CLEAN mode appears. Press START.

3.The default cleaning time is 4 hours. To change cleaning time, turn knob to change number of hours. Otherwise, continue to step 4.

4.Press START.

English 39

Page 43
Image 43
Siemens HG2425UC, HG2528UC manual Self Clean, Remove Racks, Setting the Self-Clean Mode Delaying the Start of the Self-Clean