Siemens SL 740 Using a handset as a room monitor, Step 4: Set the sensitivity:, Step 2: Activate room monitor:, Step 3: Enter the "call to" number:

Using a handset as a room monitor

With this function, a previously stored internal or external number is called when a set noise level in the room is reached. The room monitor remains activated on the handset even after you hang up.

The handset should be between 1 and 2 metres away from the baby. The microphone must be directed towards the baby.

When the room monitor is activated, incoming calls to the handset which is near the baby are indicated without a ring tone, they are just shown on the display. The display and the key pad are not illuminated.

When entering an external telephone number, make sure:

uThe handset must not be blocked for outgoing calls.

uThe number to which the room monitor call is forwarded must not be blocked by an activated answering machine.

uAlways check the settings of the room monitor before you leave home. For example, test its sensitivity. Check the phone line if the room monitor is redirected to an external number.

uA room monitor stops calling an external number after around

90 seconds. Room monitor calls to an internal number (handset) stop after about 3 minutes.

uThe activated room monitor function reduces the handset operating time considerably. Place the handset in the charger to prevent the battery from going flat.

uThe room monitor function can also be used in Walk and Talk mode (p. 45).

Operating more than one handset

Activating the room monitor function and entering the "call to" numberStep 1: Open input field for room monitor:

v¢í¢Room Monitor

Step 2: Activate room monitor:

rIn Room M.: select On.

Step 3: Enter the "call to" number:

sScroll to the Call to: line.

Edit	Press the display key. The input
	field for the phone number is
	opened.

Enter an external number as the "call to" number:

s/~	Enter or select number from
	the directory.
	Only the last four digits are
	displayed.
©	Press the display key.
Save Entry	Select and press OK. The entry
	is stored.

You can also enter an internal number as the "call to" number: INT ¢s(Select handset) OK.

Step 4: Set the sensitivity:

sScroll to the Level: line.

rSelect sensitivity for the noise level (Low or High).

Save	Press the display key. The
	room monitor function is now
	activated.

Once the room monitor is activated, switch directly to the room monitor setting with v(open menu).

43