MVDS
3.1.2 Functions available in each menu
This section explains the functions available in LCD menu.
Initial screen (Level:0)
This screen is always displayed while this product is turned on. When this product is running properly, the model name and operating status are shown in the upper line and lower line respectively. When an error occurs or the firmware of this product is being updated, operating status is displayed in both upper and lower lines.
Initial screen (sample)
silex
Operating status
Model name Operating status
Upper line | Operating status | Lower line | Details | |
|
|
| Normal status | |
|
| TX:** RX:**** | The number of transmitters and receivers | |
| Operating |
| being connected is displayed. | |
(Model name) | Please wait... | Processing MVDS boot. | ||
normally | ||||
|
| Rebooting | ||
|
|
| ||
|
| *** REBOOTING *** | Displayed when rebooted via Web page, | |
|
|
| Telnet or LCD panel. | |
|
|
| No VGA signal is input. | |
NO VGA SIGNAL! |
| (None) | Check the connection between the | |
|
|
| player(s) and this product. | |
|
|
| Incorrect VGA signal | |
| Error |
| The frequency of the input signal is | |
Out of range |
| V **Hz or H **kHz | displayed in the lower line. | |
| Refresh note error: V **Hz | |||
|
|
| ||
|
|
| Resolution error: H **kHz | |
|
|
| Please check the output settings of player. | |
|
| EEPROM ERASE.... | Deleting an old firmware. | |
|
|
| ||
| Updating |
|
| |
** F/W UPDATE** | >>>>* | Writing a new firmware. | ||
firmware | The progress is displayed. | |||
|
| |||
|
| Succeeded in the firmware update. | ||
|
| CHECKSUM ERROR! | Failed in the firmware update. |
36