10 Basic Functions
You can use your 8in1 multifunctional SilverCrest
10.1 Battery
Inserting the Battery
Ensure that the device is switched off and is not connected to the mains supply or a computer. Open the battery case by sliding back the battery cover 
in the direction shown
.
Insert the rechargeable battery so that the battery’s connecting contacts point in the direction of the device, and are located on the side of the battery case hinges. Ensure that the rechargeable battery locks into place. Finally, close the battery cover.
Note:
To increase the life of your battery, you can save energy in the following ways:
Only use the camera rarely as a flashlight (see page 13).
Activate the automatic
Please pay attention to the following information regarding the battery, and the note on the disposal of batteries on page 46.
Important Battery Information:
Always observe the correct polarity when inserting the battery. Only replace the battery with another battery of the same or comparable type. A risk of explosion exists if the battery is not replaced properly.
Batteries can be fatal if swallowed. Keep the battery out of reach of young children. If a battery has been swallowed, seek medical assistance immediately.
Do not place the battery on a flame or source of heat. Never
Never change the batteries in surroundings that could potentially cause an explosion. When inserting or removing the battery, sparks may occur, which could cause an explosion. Areas in which a risk of explosion exists are often, but not always, indicated as such. These include fuel areas, such as below deck in a boat, fuel transfer points, fuel storage areas, areas in which the air contains chemicals or particles, such as grain, dust or metal powder, as well as all other areas in which you are usually advised to turn off your vehicle’s engine.
See also the note on the disposal of batteries on page 46.
9
