Jaguar Model | 35 | |
|
|
|
III. INITIAL START
Safe lighting and other performance criteria were met when testing various gas manifold and control assemblies used on the Jaguar
Instructions
Follow the lighting instructions in this manual. These instructions are also attached to the boiler.
TURN 90˚
TO OPEN
TURN 90˚
TO CLOSE
GAS SUPPLY SHUTOFF VALVE | GAS SUPPLY SHUTOFF VALVE |
IN "OPEN" POSITION | IN "CLOSED" POSITION |
Figure 24. Gas supply shutoff valve operation.
SAFETY INFORMATION
For Your Safety Read Before Operating
WARNING: If you do not follow these instructions exactly, a fire or explosion may result causing property damage, personal injury or loss of life.
A.This appliance does not have a pilot. It is equipped with an ignition device which automatically lights the burner. DO NOT try to light the burner by hand.
B.BEFORE OPERATING smell all around the appliance area for gas. Be sure to smell next to the floor because some gas is heavier than air and will settle on the floor.
WHAT TO DO IF YOU SMELL GAS:
•DO NOT try to light any appliance.
•DO NOT touch any electric switch: DO NOT use any phone in your building.
•Immediately call you gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions.
•If you cannot reach your gas supplier, call the fire department.
C.Use only your hand to turn the gas supply
D.DO NOT use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water.
OPERATING INSTRUCTIONS
1.STOP! Read the safety information above.
2.Set the thermostat to lowest setting.
3.Turn off all electric power to the appliance.
4.This appliance is equipped with an ignition device which automatically lights the burner. DO NOT try to light the burner by hand.
5.Open the gas supply
6.Wait five (5) minutes (longer for propane) to clear out any gas, then smell for gas, including near the floor. If you then smell gas, STOP! Follow “B” in the safety information above on this page. If you don’t smell gas, go to next step.
7.Turn on all electric power to the appliance.
8.Set thermostat to desired setting.
If the appliance will not operate, follow the instructions “To Turn Off Gas to Appliance” and call your service technician or gas supplier.
TO TURN OFF GAS TO APPLIANCE
1.Set thermostat to lowest setting.
2.Turn off all electric power to the appliance if service is to be performed.
3.Close the gas supply shut off valve, by turning the handle to be perpendicular to the gas piping. (See Figure 24).
