i n t e l l i g e n t | w i r e l e s s | p l a t f o r m |
The Radio and Ethernet interfaces are assigned to bridge group by default. When the user enables STP and assigns a priority on bridge, STP is enabled on the radio and Ethernet interfaces. The interfaces adopt the priority assigned to bridge.
The user can edit STP Priority, Bridge Max age, Bridge hello time, Forward Delay, STP Port priority and STP Port Path cost.
The Transparent Aging Time determines the time to refresh entries in the Forwarding Table. The Transparent Aging Time default value is 300 seconds.
Follow the steps below to configure the bridge STP for device in airPoint Bridge:
1.Click on ’Networking Bridge Configuration’ to access the Bridge Configuration page.
2.Choose ’Enable’ from the Spanning Tree Protocol pull down list.
3.Click on the ’Generic Port Table’ link to change the Generic Parameters.
4.Enter a value for the ’STP Priority’.
5.Enter a value for the ’Bridge Max Age’
6.Enter a value for the ’Bridge Hello Time’
7.Enter a value for the ’Bridge Forward Delay’
8.Click on’ Transparent Aging Time’ link to change the ’Transparent Aging Time’
9.Click on the ’Spanning Tree Port Table’ link to change the ’STP Ethernet Port’ parameters.
10.Enter the values of Ethernet Port Priority and/or Port Path Cost for ETHA
11.Enter the values of Ethernet Port Priority and/or Port Path Cost for ETHB
12.Enter the values of Ethernet Port Priority and/or Port Path Cost for Radio A
13.Click on ’Apply Changes’ Button to save to the current configuration file.
airPoint™ Nexus User Configuration Guide | Page 24 of 55 |
|
