SMC Networks M8501 manual 2. Fault Symptom Codes, Message

TroubleshootingFault Symptom Codes (FSCs)

Table 6-2. Fault Symptom Codes

Message	FSC	ERP
SCSI FIFO Error	1003	D, G	The SCSI controller data FIFO should be
			empty but still contains data bytes.
SCSI Gross Error	1004	C, D, G The SCSI controller detected a gross
			error condition - invalid SCSI bus phase
			or DMA error.
Illegal SCSI Cnt Cmd	1005	C, D, G Either an invalid command was sent to
			the SCSI controller, or the controller was
			not in the correct mode.
SCSI Invalid Element	1007	D, G	Internal SCSI task processing error -
			invalid element type was detected.
SCSI Invalid Int.	1009	D, G	The SCSI controller posted an invalid
			interrupt status.
Loader Not Ready	2004	C, G	Fail to fetch, stow, scan, move passthru,
			Or when loader detects invalid command,
			aborts command.
Door Open (status	2009	F	Door is force opened or door sensor
only)			failed.
Cart Inaccessible	200C	F	For an LTO, indicates the tape is not
			ejected. Cartridge in drive is not
			accessible from changer.
Drive In Error	200D	C, G	A general drive error detected by control
			task.
No Magazine	200E	F	Cannot move, element not installed, from
			changer.
Removal Prevented	200F	F	Receive medium prevent removal from
			drive for a fetch.
Ctl. Firmware Error	2010	C, G	Internal inter task processing error.
			Unexpected event. SMX send or receive
			error.
Drive Time-out Error	2030	C, G	Can’t communicate with DLT drive.
Drive Code Update	2080	C, G	Update code from SCSI or from TAPE
Command Error			failed.
Move Command	2081	C, G	Move command from / to drive slot failed,
Failure			detected by control task.
Open Mail Slot Fault	2090	C, G	Door open sensor time-out detected when
			open door.
Open Left Door Fault	2091	C, G	Door open sensor time-out detected when
			open door.
Open Right Door Fault	2092	C, G	Door open sensor time-out detected when
			open door.

M8501 and M8502 ACL Tape Drive Installation and User’s Guide — 529972-001

6-4